The LR4 produces 310 horsepower (230 kW) to 325 horsepower (242 kW).
GM Vortec engine
Chevrolet small-block engine
Vortec is a trademarked name for a line of piston engines for General Motors trucks. The name first appeared in 1988 on a 4.3 L V6 that used "vortex technology" to create a vortex inside the combustion chamber, creating a better air/fuel mix. Now it is used on a wide range of different engines. Modern Vortec engines are named for their approximate displacement in milliliters.
Hybrid electric vehicles
The Chevrolet small-block engine is a series of automobile V8 engines built by the Chevrolet Division of General Motors using the same basic small (for a V8) engine block. Retroactively referred to as the "Generation I" small-block, it is distinct from subsequent "Generation II" LT and "Generation III/IV" LS, and "Generation V" (LT/EcoTec3) engines. Engineer Ed Cole, who would later become GM President, is credited with leading the design for this engine.
Production of the original small-block began in the fall of 1954 for the 1955 model year with a displacement of 265 cu in (4.3 L), growing incrementally over time until reaching 400 cu in (6.6 L) in 1970. Several intermediate displacements appeared over the years, such as the 283 cu in (4.6 L) that was available with mechanical fuel injection, the 327 cu in (5.4 L) (5.3L), as well as the numerous 350 cu in (5.7 L) versions. Introduced as a performance engine in 1967, the 350 went on to be employed in both high- and low-output variants across the entire Chevrolet product line.
A hybrid electric vehicle (HEV) is a type of hybrid vehicle and electric vehicle which combines a conventional internal combustion engine (ICE) propulsion system with an electric propulsion system. The presence of the electric powertrain is intended to achieve either better fuel economy than a conventional vehicle or better performance. There are a variety of HEV types, and the degree to which they function as EVs varies as well. The most common form of HEV is the hybrid electric car, although hybrid electric trucks (pickups and tractors) and buses also exist.
Modern HEVs make use of efficiency-improving technologies such as regenerative braking, which converts the vehicle's kinetic energy into electric energy to charge the battery, rather than wasting it as heat energy as conventional brakes do. Some varieties of HEVs use their internal combustion engine to generate electricity by spinning an electrical generator (this combination is known as a motor-generator), to either recharge their batteries or to directly power the electric drive motors. Many HEVs reduce idle emissions by shutting down the ICE at idle and restarting it when needed; this is known as a start-stop system. A hybrid-electric produces less emissions from its ICE than a comparably sized gasoline car, since an HEV's gasoline engine is usually smaller than a comparably sized pure gasoline-burning vehicle (natural gas and propane fuels produce lower emissions) and if not used to directly drive the car, can be geared to run at maximum efficiency, further improving fuel economy.
GM LS engine
A pickup truck, often simply referred to as a pickup or pick-up, is a light motor vehicle with an open-top, rear cargo area (bed).
In North America, the term pickup is used for light trucks with a lighter duty chassis and factory built, integrated bed, as well as for coupé utility vehicles, often based on a personal car chassis, but also often on a special dedicated chassis for such use.
GM Atlas engine
The GM LS engine family is an engine design intended as the only V-8 engine used in General Motors' line of rear-wheel-drive cars and trucks. The LS series was a "clean sheet" design with little in common in terms of shared parts with the classic Chevrolet small block V8. The basic layout owes a good deal to the essential concept of Ed Cole's original small-block design of 1954-55, though the LS engine also uses design cues from Buick Oldsmobile and Pontiac engines. Some LS engines are all-aluminum, especially the performance oriented engines, while others are cast iron, and all LS engines have six-bolt main bearing caps.
The LS engine has been the sole powerplant of the Chevrolet Corvette since 1997 and has seen use in a wide variety of other General Motors vehicles, ranging from sport coupes to full size trucks. Due to the engine's relatively compact external dimensions compared to its displacement and power output, the engine family is also a popular choice for kit cars, hot rods, buggies, and even light aircraft.
Atlas is a name for a family of modern inline piston engines for trucks from General Motors. The series debuted in 2002 with the Oldsmobile Bravada, and is also used in the Chevrolet TrailBlazer and Colorado and their GMC twins, the Envoy and Canyon. In production, the engines use GM's Vortec name, and I4, I5, and I6 engines are all part of the same family, sharing the same manufacturing equipment, rods, pistons, valves, and other parts. They feature variable valve timing on the exhaust side, electronic throttle control, and a special oil pan with a pass-through for the half shafts in four-wheel drive vehicles. The inclusion of VVT on the exhaust camshaft side allows the Atlas series to meet emissions standards without the use of EGR, simplifying the engine design and increasing power for a broad power curve.
The Atlas program began in 1995 along with the planning for GM's next-generation mid-size SUVs and pickup trucks. These vehicles were designed around the I6 engine. The I6 version was used in a Baja 2000 racing truck, winning its first race in a class that also included V8 engines. Another I6-powered truck won the truck class at the Pikes Peak International Hillclimb.